|
Bottle Anatomy
The most important parts of the bottle to notice are the “shoulder” and
the “hip”. These points are where the bottle begins to narrow
at the top and the bottom, and are where bottles are fit together. Generally,
you will cut bottles just below or above the shoulder or hip, depending
on the system you ’re building.
Because the diameters of bottles from different brands
may vary (Coke vs. Pepsi, for example), it’s a good idea to construct
any one bottle using only one brand.
Removing the
Skin
You’ll need a hairdryer to remove the skin:
- Leave the cap on or fill the bottle with water to prevent warping.
- Hold the bottle between your thighs so you have one hand free for
the hairdryer and one free to pull the label off.
- Set the hairdryer on low.
- Hold the bottle about 10 cm from the blowing
nozzle, and move it rapidly up and down so the air warms the
seam of the label.
Keep the nozzle moving so the bottle doesn’t overheat and warp.
- Gently pull on an edge of the label until you feel the glue begin
to give. Then pull the label off!
| |
prev: bottle basics intro